The chance of hearing damage depends on the listening frequency and duration. Can bluetooth devices of different brands be connected to each other? Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.
What is bluetooth? Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves.
The distance between the two devices that exchange data can in most cases be no more than ten metres. What is HDMI? An HDMI cable is used to transport audio and video signals between devices. How can I best clean my Hi-Fi system? A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. An HDMI cable is used to transport audio and video signals between devices.
How can I best clean my Hi-Fi system? A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air. Wat is Dolby Atmos? Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5. This manual is available in English.
Hi-Fi system. Electric shock or damage to the unit can occur if the unit is repaired, disassembled or reconstructed by unqualified persons. Extend operating life by disconnecting the unit from the power source if it is not to be used for a long time. Table of contents Before use Safety precautions. Back cover Simple set-up and play Locating. This product may receive radio interference caused by mobile tele- phones during use. If such interference is apparent, please in- crease separation between the product and the mobile telephone.
For United Kingdom and Republic of Ireland www. Excluding public holidays. Or go on line through our Internet Accessory ordering application. Most major credit and debit cards accepted. All enquiries transactions and distribution facilities are provided directly by Panasonic UK Ltd.
It couldn't be simpler! For all other product related enquiries, please use the Customer Care Centre numbers listed above.
Inside of product. Reduce the volume in the following cases to avoid damage. When playing distorted sound. When the speakers are receiving howling from a microphone for Australia and N. When adjusting the sound quality. When turning the unit on or off. If irregular colouring occurs on your television These speakers are designed to be used close to a television, but the picture may be affected with some televisions and set-up combinations.
If this occurs, turn the television off for about 30 minutes. The television's demagnetizing function should correct the problem. If it persists, move the speakers further away from the television. Note The wall or pillar on which the speakers are to be attached should be capable of supporting 5 kg per screw. Front speakers Left and right front speakers are exactly same. Surround speakers Place either side of the listening position, or slightly to the rear, about 1 meter higher than ear level with the Technics logo facing toward the listening position.
The effect varies with the type of music and the music source. Attaching to a wall Set the speaker onto screws and slide through bracket to lock into position.
Heat can damage your CDs. Using other speakers can damage the unit and sound quality will be neg- atively affected.
Caution Use the speakers only with the recommended system. Consult a qualified service person if damage has occurred or if you experience a sudden change in performance. Do not attempt to attach these speakers to walls using methods other than those described in this manual.
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5-ampere fuse is fitted in this plug.
If the plug contains a removable fuse cover you must en- sure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local dealer. If a new plug is to be fitted please observe the wiring code as stated below. If in any doubt please consult a qualified electrician. As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black or Blue.
The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Brown or Red. Before use Remove the connector cover. How to replace the fuse The location of the fuse differ according to the type of AC mains plug figures A and B.
Confirm the AC mains plug fitted and follow the instructions below. Illustrations may differ from actual AC mains plug. Open the fuse cover with a screwdriver. Replace the fuse and close or attach the fuse cover. For Australia and N. Twist the vinyl tip and pull off.
Front speaker Connect the leads to the terminals of the same colour. LF and HF stand for low frequency and high frequency. Connect the left L side in the same way. Note Never short-circuit positive r and nega- tive s speaker wires.
Be sure to connect only positive red or grey wires to positive r terminals and negative black or blue wires to negative s terminals. Incorrect connection can damage the speakers. AM indoor antenna Twist the vinyl tip and pull off. Keep loose antenna cord away from other wires and cords.
Connect the connectors to the terminals of the same colour. Incorrect connection can damage the unit. AC mains lead Insertion of connector Even when the connector is perfectly in- serted, depending on the type of inlet used, the front part of the connector may jut out as shown in the drawing.
However there is no problem using the unit. For your reference: Information you enter into the unit's memory, except for time, remains intact for up to two weeks after the mains lead is disconnected. Do not connect the AC mains lead until all other connections are complete. Displayed when the unit is in CD mode. To stop the disc Press []. To pause play Press [;] during play. The "! Press [;] or [! In standby mode, the unit is still consuming a small amount of power. N Disc direct open buttons.
Before connecting, operating or adjusting. Please keep this manual for fu-. Please check and identify the supplied.
Use numbers indicated in parentheses when. The included AC mains lead is for use with this unit only. Do not use. Remote control batteries. FM indoor antenna.
0コメント